Table of Contents
Advertisement
ELECTRICAL CONNECTION
The electrical connections must comply with current
legislation and be carried out by a qualified, competent
person.
• Information on the voltage and power absorbed are
shown on the serial no. plate.
• The appliance must be earthed.
• When installing the appliance, we recommend that this
hob is protected by a 3 mm bi-polar switch.
• If damaged, the power cable must be replaced with an
identical type of power cable (H05V2V2-FT90ºC, or
H05RR-F type). We recommend that this operation be
conducted by our After Sales Service. Please contact
our Customer Care Centre on 00800-3810-4026.
• Do not use extension cables.
• The manufacturer declines all responsibility for damage
to persons, pets or goods as a result of failure to comply
with the regulations above.
FIXING THE HOB TO THE WORK TOP.
TRADITIONALLY FITTED MODEL
Important: The following procedure must be carried out
by competent technical personnel only. The hob can be
installed on, or into different types of materials, such as
masonry, metal, wood and heat resistant laminate coated
wood (90°C).
Cut an opening in the worktop to the dimensions shown in the
diagram.
Carefully place the gasket/seal on the external outline of the
worktop, as shown in the diagram below. Apply a light but firm
pressure to ensure a good adhesion to the work surface.
Fix the hob into the unit, and secure using the fixing brackets
provided.
Note: the electrical power cable must be long enough to allow
the hob to be lifted out from above.
24
L
Earth
(yellow/green)
N
Advertisement
Table of Contents
