Table of Contents
Advertisement
31902052GB.fm Page 13 Wednesday, September 3, 2008 4:05 PM
Installation and fixing
WARNING! The installer is responsible for any
damage or injury resulting from incorrect
installation.
To guarantee correct operation, the appliance must
be installed on a perfectly flat surface.
For cut-out dimensions, see the figure below.
Domino
300
288
484
min. 50
+2
0
490
To guarantee correct operation, the appliance must be
installed on a perfectly flat surface.
The worktop must be 20-50 mm thick.
If necessary, cut the kitchen unit and worktop to fit before
installing the hob. Clean the cutout of any remaining dust that
could compromise appliance operation.
For the distance between the underside of the induction hob
and the kitchen unit (or separating panel), observe the
dimensions given in the figure at the side. If a column unit is
installed adjacent to the hob, leave a distance of at least
100 mm from the edge of the hob.
Assembly
1. Position the clips (A) in the spaces provided on the hob
trim (fig. 3) if not already positioned.
2. Measure the centre point of the vertical sides of the cut-
out (fig. 1)
3. Fit the brackets (C) in the centre of the vertical sides,
aligning the upper edge of the brackets so that they are
flush with the worktop surface (fig. 2).
510
+1
0
51
267
R min. 6.5
max. 8
+2
380
0
275
Domino
380
484
min. 50
+2
0
490
fig. 1
The worktop must be -20 50mm thick.
If necessary, cut the kitchen unit and worktop to fit before
installing the hob. Clean the cutout of any chips that could
compromise appliance operation.
77x35
770
325
min. 50
+2
0
330
510
+1
0
51
342
R min. 6.5
max. 8
+2
0
350
min. 20
min. 5
4. Fix the brackets with the 4 screws supplied (B) using the
holes provided.
5. Insert the hob in the cutout, making sure the clips (A) are
secured in the spaces provided (fig. 4).
C
B
350
+1
0
52
743
R min. 6.5
max. 8
+2
0
750
Dimensions
in mm
fig. 2
13
Advertisement
Table of Contents
