Table of Contents
Advertisement
Figure 28
Important:
Position the curved ends of the
blade facing up toward the machine housing.
5.
Use a torque wrench to tighten the blade bolt
to 88 N∙m (65 ft-lb).
Adjusting the Self-Propel
Drive
For Self-Propel-Drive Models Only
Whenever you install a new self-propel cable or if
the self-propel drive is out of adjustment, adjust the
self-propel drive.
1.
Turn the adjustment nut counterclockwise to
loosen the cable adjustment
g231390
1. Handle (left side)
2. Adjustment nut
3. Self-propel-drive cable
2.
Adjust the tension on the cable
pulling it back or pushing it forward and holding
that position.
Note:
Push the cable toward the motor to
increase the traction; pull the cable away from
the motor to decrease the traction.
3.
Turn the adjustment nut clockwise to tighten the
cable adjustment.
Note:
Tighten the nut firmly with a socket or
wrench.
29
(Figure
29).
Figure 29
4. Turn the nut clockwise to
tighten the adjustment.
5. Turn the nut
counterclockwise to
loosen the adjustment.
(Figure
g269307
29) by
Advertisement
Table of Contents
