Control iD iDUHF Lite Quick Manual

iDUHF Lite – Quick Guide
Thank you for purchasing the iDUHF Lite Access Controller! For more information,
visit:
https://www.controlid.com.br/en/access-control/iduhf-lite/
By using Control iD products, you accept the Terms and Conditions of Use and
Personal Data Protection Information available at:
https://www.controlid.com.br/legal/acessoeponto.pdf
1. Necessary Material
For the physical installation of your iDUHF Lite, the following items are required:
EAM – External Access Module [1] , installation kit (support part + clamp + screws),
a 13mm wrench [2] , a 12V/2A DC supply
2
.
[1] Optional according to installation scenario.
[2] Items sold separately.
Use a high-quality, noise-free 12V/2A supply to ensure full product
operation.
2. Physical Installation
Installation of the equipment is simple and should follow the sequence below:
a) Attach the support part of the installation kit to the back of the iDUHF Lite,
using the four screws that come with the product and a wrench.
b) Use the support piece clamps and fixed wrench to place the iDUHF Lite on the
support mast previously installed in the environment.
Make sure the iDUHF Lite connectors are point downwards.
c) With the help of a fixed wrench, adjust the angle of the iDUHF Lite so that its
front face points towards the place where vehicles pass. Consider, in the
process, that the emitted signal has an aperture of 30° in all directions.
Do not install two iDUHF Lite units covering the same reading region.
[2] and an antenna support mast installed
Quick Guide – iDUHF Lite– Versão 1.3 – Control iD 2023 ©
d) Identify your installation scenario in item 4 of this document and make the
electrical connections described in the corresponding diagram.
e) Route the cables through the holes of the sealing piece and fit it to the
product to protect it from external environmental factors.
3. Description of Connection Pins
The iDUHF Lite has a dedicated network port (Ethernet) for setting its parameters
and integration with Control iD's access software (iDSecure), as well as a 14-
position terminal bar to ensure communication with the EAM and complete
integration. with different installation environments.
Check the following table with the descriptions of the External Actuation Module
– EAM and iDUHF Lite interfaces.
EAM – 2-pin Connector (Power)
EAM – 4-pin Connector (Connection with iDUHF Lite)
EAM – 5-pin Connector (Wiegand In/Out)
EAM – 6-pin Connector (Relay Control)
iDUHF Lite – 14-pin Connector
GND Terra da Fonte
12V Alimentação 12V
W0O Saída Wiegand
W1O Saída Wiegand
485A Comunicação RS485 (Pino A)
485B Comunicação RS485 (Pino B)
TGR Sensor Gatilho
DS Sensor de Porta
TX RS-232 TX / 115200 bps 8N1
RX RS-232 RX / 115200 bps 8N1
NO Contato Normalmente Aberto
COM Contato Comum
NC Contato Normalmente Fechado
GND Terra da Fonte
EAM – Communication modes
• Default: EAM will communicate with any equipment
Máx 30VDC