Technical Data - Electrolux ERB36502W8 User Manual

Problem
The appliance does not
operate.
The lamp does not work.
As much as the advice does not lead to result, call the nearest brand-mark service.
Replacing the lamp
If you want to replace the bulb, do these
steps:
1. Break the circuit of the appliance.
2. Unscrew the lamp cover securing screw.
3. Unhook the moving part by pressing it as
shown in the figure.
4. Replace the bulb with one of the same
power (the maximum power is shown on
the light bulb cover)
5. Fix the lamp cover in place.
6. Screw the lamp cover securing screw.
7. Reconnect the appliance.
8. Open the door and check if the light
comes on.

Technical data

Dimension
Rising Time
The technical information are situated in the
rating plate on the internal left side of the ap-
pliance and in the energy label.
Possible cause
The appliance is switched off.
The mains plug is not connected
to the mains socket correctly.
The appliance has no power.
There is no voltage in the mains
socket.
The lamp is in stand-by.
The lamp is defective.
Height
Width
Depth
Switch on the appliance.
Connect the mains plug to the
mains socket correctly.
Connect a different electrical appli-
ance to the mains socket. Contact
a qualified electrician.
Close and open the door.
Refer to "Replacing the lamp".
2
Closing the door
1. Clean the door gaskets.
2. If necessary, adjust the door. Refer to "In-
stallation".
3. If necessary, replace the defective door
gaskets. Contact the Service Force Cen-
ter.
ENB36502W8
1850 mm
595 mm
632 mm
20 h
electrolux 31
Solution
1
3
ENB36502X8
1850 mm
595 mm
632 mm
20 h