Quick View Of Function Codes - Vaidnor VDF650 Series User Manual

Operation, Display and Application Examples
PP-02 is used to determine whether group A and group U are displayed.
Function
Parameter Name
Code
AC drive parameter
PP-02
display property

4.4 Quick View of Function Codes

The VDF650 provides two quick modes of viewing the required function codes.
1) You can defne a maximum of 30 function codes into group PE.
2) The VDF650 automatically list the modifed function codes.
In this case, the operation panel provides three viewing modes: base mode, user-defned
mode and user-modifed mode, as listed in the following table.
Function Code Display Mode
You can perform switchover between the three function code display modes by
. The method of viewing and modifying function codes in each mode is the
pressing
QUICK
same as the method of operating the operation panel described above.
Figure 4-5 Switchover between three function code display modes
Status parameters
(Default display)
50.00
Level I menu
Press /
to view
function codes in turn in
the corresponding range
Press ENTER to view the
parameter value.
The right side is only
example of function codes.
Unit's digit (group U display selection)
0: Not display
1: Display
Ten's digit (group A display selection)
0: Not display
1: Display
Base mode
User-defned mode
User-modifed mode
Base mode
(All function codes)
QUICK
-bASE
No key
operation within
ENTER
2 seconds
P0
A0
.
U3
Setting Range
Display
QUICK
User-defined mode
(Group FE)
-USEr
QUICK
PP-03 = x1
ENTER
uP0.03
uP0.07
uP5.04
- 50 -
VDF650 User Manual
Default
11
User-modified mode
(Modified function codes )
--C--
QUICK
PP-03 = 1x
ENTER
cP0.01
cP0.03
cA9.10