Download Print this page
Panasonic CZ-RTC6 Installation Instructions Manual
Panasonic CZ-RTC6 Installation Instructions Manual

Panasonic CZ-RTC6 Installation Instructions Manual

Wired remote controller

Advertisement

ENGLISH
Read through the Installation Instructions before you proceed with the installation.
In particular, please carefully read the "Safety Precautions".
Model No.
 Safety Precautions ........................... 2
 Part Names (Control panel) .................. 4
 Dimensions ....................................... 4
 Installation Precautions ..................... 5
 Mounting .......................................... 6
 Setting ............................................. 9
.......................................... 11
Installation Instructions
Wired Remote Controller
CZ-RTC6
CZ-RTC6W
................................. 11
WEB-ACXF60-38393-EN
W1020-20423
Page

Advertisement

loading

Summary of Contents for Panasonic CZ-RTC6

  • Page 1: Table Of Contents

    Installation Instructions Wired Remote Controller CZ-RTC6 Model No. CZ-RTC6W Page  Safety Precautions ……………………… 2  Part Names (Control panel) ……………… 4  Dimensions ………………………………… 4  Installation Precautions ………………… 5  Mounting …………………………………… 6  Setting ……………………………………… 9  Test run ……………………………………...
  • Page 2: Safety Precautions

    NOTICE The English text is the original instructions. Other languages are translations of the original instructions. Safety Precautions Read before installation  Read the Installation Instructions carefully to install the remote controller correctly and safely.  Be sure to read the “Safety Precautions” before installation. ...
  • Page 3 CAUTION Do not use the remote controller at the following  locations. • Location where condensation occurs  • Location where fl ammable gases, etc. may leak  • Location where corrosive gases, etc. may leak  • Location with lots of water or oil droplets ...
  • Page 4: Part Names (Control Panel)

    Part Names (Control panel) The control panel colour of CZ-RTC6W is white. 1) LCD screen 2) Menu button ● When pressed repeatedly during operation, this shows operating status confi rmation, set temperature, operation mode, fan speed, fl ap, and the menu screen. 4) Enter button ●...
  • Page 5: Installation Precautions

    Installation Precautions Installation location  Install at the height of 1 to 1.5 m from the fl oor (Location where average room temperature can be detected). 50 mm  Install vertically against a wall or suitable supporting structure.  Keep a space around the remote controller as detailed on 50 mm 50 mm the fi...
  • Page 6: Mounting

    After installation, set one remote controller to [Main] and the other to [Sub] for [Main/sub] for “Setting”. (See “Setting” section - “RC. setting mode”) When using the remote controllers* in combination, set the CZ-RTC6(CZ-RTC6W) unit to [Sub]. *CZ-RTC5B, CZ-RTC6BL(CZ-RTC6WBL) Note Remote controllers can be connected to any indoor unit for operation.
  • Page 7 Mount to the wall. There are 2 types of wall-mounting methods: Exposed type and Embedded type. Attention Mounting the bottom case  Tighten the screws securely until the screw heads touch the bottom case. (Otherwise, loose screw heads may hit the PCB and cause malfunction when mounting the top case.) ...
  • Page 8 Embedded type A protective fi lm is attached on the Control panel. Mount the top case. Mount the bottom case to ● Align the claws of the top Pass the wire under the rib. Pass the wire under the rib. the wall.
  • Page 9: Setting

    Setting Preparation: Turn on the circuit breaker of units and then turn the power on. The remote controller starts, and wait until the [Assigning] display disappears. (If [Assigning] continues to blink for 10 minutes or more, check the address setting of indoor units.
  • Page 10 Auto address Set. ( Select the Code no. [A1] and O/D unit no.) Code no. Press → . (Repeat) O/D unit no. Press  After Selecting [YES], the unit restarts. Code no. O/D unit no. Set the Auto address for each O/D unit no. •...
  • Page 11: Test Run

     Do not use this mode for purposes other than the test operation. (To prevent overload of the units)  Read the Installation Instructions supplied with the units. Specifi cations Model No. CZ-RTC6 / CZ-RTC6W Dimensions (H) 86 mm × (W) 86 mm × (D) 25 mm Weight 0.09 kg 0 ˚C to 40 ˚C / 20 % to 80 %...
  • Page 12 Panasonic Corporation http://www.panasonic.com WEB-ACXF60-38393-EN © Panasonic Corporation 2020-2023 W1020-20423...

This manual is also suitable for:

Cz-rtc6w