Mounting The Sensor; Mounting The Sensor With The Tamper Screw - Multitech RBS3010NA05BN00 User Manual

Mounting the Sensor

Do not mount higher than 2 meters from floor surface.
To mount the sensor:
Use the large adhesive pad included with a sensor to secure the case in position.

Mounting the Sensor with the Tamper Screw

For increased security, open the case, and fasten it to the wall using the included tamper screw as shown. Then
reassemble the case. The tab will break away and send a tamper alert if the case is forcibly removed.
1. Open the case. To do this, use a pen or similar object to press the button on the opposite side of the
case.
2. Stick the adhesive pad where you want to install the sensor.
3. Attach the case over the adhesive using the included tamper screw as shown.
4. Reassemble the case.
The tab will break away if the case is forcibly removed. If you enabled the sensor's tamper option, the sensor sends
a tamper alert. (Note: Tamper switches are disabled by default.)
®
Radio Bridge LoRaWAN Wireless Sensor External Probe Temperature Sensor User Guide
QUICK START
7