Table of Contents
Advertisement
AXIS M43 Series Panoramic Camera
Configure your device
The following example shows how to configure a rule that turns on the AXIS I/O Indication LED to indicate that camera is recording.
1. Go to System > Accessories > I/O ports.
2. For the port that you connected the AXIS I/O Indication LED to, click
to set the normal state to Circuit open.
3. Go to System > Events.
4. Create a new rule.
5. Select the Condition that must be met to trigger the camera to start recording. It can, for example, be a time schedule or
motion detection.
6. In the list of actions, select Record video. Select a storage space. Select a stream profile or create a new. Also set the
Prebuffer and Postbuffer as required.
7. Save the rule.
8. Create a second rule and select the same Condition as in the first rule.
9. In the list of actions, select Toggle I/O while the rule is active, and then select the port the AXIS I/O Indication LED is
connected to. Set the state to Active.
10. Save the rule.
Other scenarios where AXIS I/O Indication LED can be used are for example:
•
Configure the LED to turn on when the camera starts, to indicate the presence of the camera. Select System ready as
a condition.
•
Configure the LED to turn on when live stream is active to indicate that a person or a program is accessing a stream from
the camera. Select Live stream accessed as a condition.
Detect tampering with input signal
This example explains how to send an email when the input signal is cut or short-circuited. For more information about the
I/O connector, see page 57.
1. Go to System > Accessories and turn on Supervised for the relevant port.
Add an email recipient:
1. Go to System > Events > Recipients and add a recipient.
2. Type a name for the recipient.
3. Select Email.
4. Type an email address to send the email to.
5. The camera doesn't have it's own email server, so it has to log into another email server to send mails. Fill in the rest of the
information according to your email provider.
6. To send a test email, click Test.
7. Click Save.
Create a rule:
1. Go to System > Events > Rules and add a rule.
2. Type a name for the rule.
to set the direction to Output, and click
15
Advertisement
Table of Contents
