Samsung WD9102RNW User Manual page 17

STEP 3
Adjusting the levelling feet
When installing your washing machine, ensure that the power plug, the water supply and
the drain are easily accessible.
1. Slide the washing machine into position.
2. Level your washer by turning the adjustable nut, as shown
in the fi gure.
3. When your washing machine is level, tighten the locking
nut using the (-) screwdriver.
STEP 4
Connecting the water and drain
Connecting the water supply hose
1. Take the L-shaped arm fi tting for the cold water
supply hose and connect it to the cold water
supply intake on the back of the machine.
Tighten by hand.
The water supply hose must be connected
to the washing machine at one end and to
the water tap at the other. Do not stretch the
water supply hose. If the hose is too short,
replace the hose with a longer, high pressure
hose.
2. Connect the other end of the cold water supply
hose to your sink's cold water tap and tighten
it by hand. If necessary, you can reposition the
water supply hose at the washing machine end
by loosening the fi tting, rotating the hose, and
retightening the fi tting.
For selected models with an additional hot water intake:
1. Take the red L-shaped arm fi tting for the hot water supply hose and connect it to the hot
water supply intake on the back of the machine. Tighten by hand.
2. Connect the other end of the hot water supply hose to your sink's hot water tap and tighten
it by hand.
3. Use a Y-piece if you only want to use cold water.
WD9102RNW-02665D_EN.indd Sec4:17 WD9102RNW-02665D_EN.indd Sec4:17
Locking nut
Adjustable nut
Option
setting up your new washing machine _17
2011-07-04 2011-07-04 10:44:59 10:44:59