England's Stove Works 50-SVL17 Installation & Operation Manual page 31

PLEASE NOTE:
The following additions to your owner's manual will enable you to achieve
optimal emissions performance from your stove. Important safety tips are also
included.
‐ Proper Installation – Please refer to the Installation section of your owner's manual and
follow the guidelines listed therein for safety and for optimal emissions performance.
Additional information:
Venting Introduction:
Draft: Draft is the force which moves air from the appliance up through the chimney. The amount
of draft in your chimney depends on the length of the chimney, local geography, nearby
obstructions and other factors. Too much draft may cause excessive temperatures in the
appliance and may damage the catalytic combustor. Inadequate draft may cause backpuffing into
the room and 'plugging' of the chimney or the catalyst.
Inadequate draft will cause the appliance to leak smoke into the room through appliance and
chimney connector joints.
An uncontrollable burn or excessive temperature indicates excessive draft.
Please be mindful of installation location: Inversion and other air quality issues can arise in valleys
or if unit is installed close to neighboring homes.
This wood stove operates on a natural draft system, in which the chimney system pulls
air through the stove. This unit must be installed in accordance with the following detailed
descriptions of venting techniques; not installing the stove in accordance with the details listed
here can result in poor stove performance, property damage, bodily injury or death. Avoid
make‐shift compromises when installing the venting system. England's Stove Works is not
responsible for any damage incurred
due to a poor or unsafe installation.
Be certain that all aspects of the venting system are installed to the venting
manufacturer's instructions, particularly the required clearances to combustibles. Also, be
certain to use an attic radiation shield to prevent insulation from contacting a chimney which
passes through an attic.
The chimney system is the "engine" which drives a wood stove, so it is imperative for
proper unit function that the venting system be installed exactly as described in the following
section.
If questions arise pertaining to the safe installation of the stove, our Technical Support
line (800‐245‐6489) is available. Contact your local code official to be certain your installation
meets local and national fire codes, and if you're uncertain about how to safely install the
stove, we strongly recommend contacting a local NFI certified installer to perform the
WOOD -
Meets the 2015 U.S. Environmental Protection Agency's crib wood
emission limits for wood heaters sold after May 15, 2015
EPA INFORMATION
Page | 31