Table of Contents
Advertisement
SPEED CONNECTION:
When using a cable drive speedometer, the metal speed pulse generator is placed in line with the
cable. This can be done at either the transmission side or the speedometer side of the cable. The two
wires from the sensor connect as follows:
Systems with black and gray wires twisted together from the sensor: BLACK wire to ground,
GRAY wire from sensor harness to GRAY wire from cruise harness.
Systems with a gray cable with a red and black wire inside:
BLACK wire to ground, RED wire from sensor harness to GRAY wire from cruise harness.
When the cruise control is used with a Dakota Digital STR3B, STR4B, STR5B, STR6B, STR3C,
STR6C, STR5D, STR6D, STR2000, VFD3, VFD3X or RET display system the gray wire should be
connected to the SPEED terminal on the display system control box.
When the cruise control is being installed into a newer vehicle which does not use a speedometer
cable consult the Vehicle Technical Information Guide supplied with the cruise. This will provide you with
information on where to connect the gray wire.
SETTING PROGRAMMING SWITCHES:
The typical application is an 8 cylinder engine, automatic transmission, and a Dakota Digital or
similar speed sensor. If your application is different, consult the GlobalCruise installation manual.
The normal setting when using a closed circuit control (turn signal switch) for the 12 switches will
be 1, 3, 4, 11, and 12 on and the rest off. When using an open circuit control (dash mount switch) 1, 3, 4,
and 11 should be on and the rest off. The description of the switch functions are found on page 7 of the
GlobalCruise manual. If you experience a surging when the cruise control engages then turn switch
number 1 off.
TROUBLE SHOOTING:
If the system fails to operate after making all of the proper connections, consult the self
diagnostics procedure on page 20. The Diagnostics LED is located beside the programming switches,
under the rubber plug on the actuator.
In order for the cruise to regulate the speed properly, the car must be tested on the road and not
with the tires elevated off the ground.
DAKOTA DIGITAL RLY-1 SHOWN. ANY 12 VOLT RELAY MAY BE USED.
TO CRUISE PURPLE WIRE
How to wire relay when using LED brake lights
GREEN
12V POWER
BLUE
GROUND
30
BLACK
4510 W. 61ST St. N., Sioux Falls, SD 57107
Phone: (605) 332-6513
www.dakotadigital.com
dakotasupport@dakotadigital.com
©Copyright 2004 Dakota Digital Inc.
RED
TO BRAKE SWITCH OUTPUT
87
86
85
GROUND
WHITE
FAX: (605) 339-4106
Advertisement
Table of Contents
