Link Layer Discovery Protocol Settings; Multicast Settings; Device Firmware Upgrade Settings; Enabling A Cli Session Time-Out - Cisco CLI User Manual

_________________________________________________________________________________________________
time, using the MONITOR
application.

8.11. Link Layer Discovery Protocol settings

Configuration objective
Activate LLDP capability.
Enable or disable the link layer
discovery protocol-data SNMP
management information
database.
Show neighboring devices that
are also LLDP-enabled.

8.12. Multicast settings

Configuration objective
NEW I Enable or disable
multicast forwarding capability.

8.13. Device firmware upgrade settings

Configuration objective
Specify the IP address of the
TFTP server containing the
needed firmware image.
Specify the file name of the
needed firmware image.
Enable or disable automated
firmware upgrades.
Specify the periodic interval at
which the device checks for the
presence of a newer firmware
upgrade package.
Force an immediate check for a
newer firmware upgrade
package.

8.14. Enabling a CLI session time-out

Configuration objective
Specify an 'inactive'
NEW I
time period after which, if user
activity is still not detected
within the CLI console, the
current user will automatically
be logged out.
__________________________________________________________________________
© 2021 Cisco and/or its affiliates.
Note that as the FM Ponte 50 is configured to work in Bridge mode only,
multicast capability can only be enabled or disabled.
multicast status D
These settings allow you to upgrade the firmware of the connected Cisco
device using trivial file transfer protocol (TFTP).
upgrade-fw-image E
Command-line interface user manual
CLI command
lldp B
lldp snmp-mib C
lldp neighbors
CLI command
CLI command
tftp-fw-upgrade
tftp-server D
tftp-fw-upgrade
tftp-fw-upgrade
automatic-upgrade
F
tftp-fw-upgrade
check-period G
tftp-fw-upgrade
check-now
CLI command
session-timeout O
All rights reserved
Parameter options
Possible values for B are
enable or disable.
Possible values for C are
enable or disable.
Parameter options
Possible values for D are
enable or disable.
Parameter options
Value D is the IP address of the
TFTP server.
Value E is the file name of the
needed firmware image.
Possible values for F are
enable or disable.
Value G is the automatic
upgrade check period in hours.
Parameter options
Value O is the specified
'inactive' time period in minutes
after which the current user will
automatically be logged out.
Possible values for O are:
• 1 to 35791 (i.e. a maximum
inactive period of 596
hours.)
• 0 (time-out option disabled.)
Page 24 of 37