Lenovo 10GS User Manual page 83

7. Remove any parts that might prevent your access to the memory module. Depending on your computer
model, you might need to remove the PCI Express x16 graphics card for easier access to the memory
module. See "Replacing a PCI Express card" on page 68.
8. Open the retaining clips and gently pull the memory module out of the memory slot.
Figure 38. Removing a memory module
9. Position the new memory module over the appropriate memory slot. Ensure that the notch
memory module aligns correctly with the slot key
straight down into the slot until the retaining clips close.
Figure 39. Installing a memory module
10. Reinstall the PCI Express x16 graphics card if you have removed it. See "Replacing a PCI Express
card" on page 68.
11. Pivot the drive bay assembly downward. See "Pivoting the drive bay assembly upward and downward"
on page 59.
12. Reinstall the optical drive. See "Replacing the optical drive" on page 57.
13. Reinstall the front bezel. See "Replacing the front bezel" on page 54.
What to do next:
• To work with another piece of hardware, go to the appropriate section.
• To complete the installation or replacement, go to "Completing the parts replacement" on page 76.
2
on the system board. Push the memory module
.
Chapter 7 Installing or replacing hardware
1
on the
73