Table of Contents
Advertisement
To replace a PCI Express card, do the following:
1. Remove any media from the drives and turn off all connected devices and the computer. Then,
disconnect all power cords from electrical outlets and disconnect all cables that are connected to the
computer.
2. Remove the computer cover. See "Removing the computer cover" on page 54.
3. Locate the PCI Express card you want to replace. The PCI Express cards are installed in the PCI
Express card slots on the system board. See "Parts on the system board" on page 8 .
4. Pivot the card latch outward to open the latch. Then, grasp the PCI Express card and gently pull
it out of the slot.
Figure 34. Removing a PCI Express card
Notes:
• The card fits tightly into the card slot. If necessary, alternate moving each side of the card a small
amount until it is removed from the card slot.
• If the card is held in place by a retaining latch, press the card retaining latch
the latch. Grasp the card and gently pull it out of the slot.
5. Insert the new PCI Express card into the appropriate PCI Express card slot on the system board.
See "Parts on the system board" on page 8 .
Note: If you are installing a PCI Express x16 graphics card, ensure that the memory slot retaining clips
are closed before you install the graphics card.
6. Pivot the card latch to the closed position.
What to do next:
• To work with another piece of hardware, go to the appropriate section.
• To complete the installation or replacement, go to "Completing the parts replacement" on page 76.
1
as shown to disengage
.
Chapter 7
Installing or replacing hardware
69
Advertisement
Table of Contents
