Table of Contents
Advertisement
MAINTENANCE
36
• Do not wash the motor with water.
5
Clean filters by brushing the dust off and wash
them in running water at least once a month.
• To avoid odour and the malfunction of the
motor, allow the exhaust filter to dry
completely in a well-ventilated area out of
direct sunlight for at least 24 hours before
reassembling.
6
Insert the dried pre-filter and rotate the
exhaust filter to the locked position
reassemble it on the product body.
Cleaning the Nozzles
Clean the nozzle and rotating brush regularly.
CAUTION
• Always separate the nozzle from the product
body or remove the battery before cleaning. If
the nozzle starts to operate during cleaning, it
could cause an injury.
• Keep fingers away from pinch points when
assembling the nozzle on the appliance or the
rotating brush on the nozzle.
• Do not use the rotating brush as a wet mop. It
may cause product damage.
• Do not rinse or submerge the rotating brush or
nozzle in water. It may cause product damage.
Cleaning the Multi-Surface
Nozzle
Clean the brush and roller heads before each use.
• If the brush contains foreign objects, the brush
may not spin or a noise may occur during
operation.
1
Press the nozzle release button
the nozzle from the extension pipe or product
body.
to
e
2
Turn the nozzle upside down and rotate the
cover lock slot
3
Pull the brush cover forward and pull the brush
out.
to remove
a
counterclockwise.
b
Advertisement
Table of Contents
