Handling And Operation; Application Instructions; Switching The Unit On And Using It; Hot Lamination - Hama KHL47 Manual

g

Handling and operation

Application instructions

■ Always set the correct temperature for the thickness of the laminat-
ing film being used.
■ When laminating thick paper or several sheets it is recommended
to use film with a low thickness.
■ Always wait until the first lamination is complete before starting the
next.

Switching the unit on and using it

Press the on/off button

Hot lamination

After the device has been switched on, the default setting is
75 μm, which is shown on the display
To change the setting press the
desired film thickness is shown on the display
Place the document to be laminated in the appropriate pouch.
When the required operating temperature has been reached, the
ready indicator
Insert the film pouch into the front opening of the device. Make
sure that the sealed end is inserted first.
NOTE
► Film pouches of all sizes should be inserted centrally into the
front opening, so that they pass by the sensor.
The document is returned at the rear.
If the item has not been fully laminated, repeat the first steps.
30
Handling and operation
8
to switch on the device.
6
button repeatedly until the
4
is constantly illuminated.
5
.
5
.
KHL 47