Philips Lumea BRI954/00R1 User Manual page 30

Problem
The device doesn't flash,
the fan is not switched on
and all 5 intensity lights
blink.
The skin feels more
sensitive than usual during
treatment. I experience
discomfort when I use the
device.
There is no glass filter in my
attachment.
The skin reaction after
treatment lasts longer than
usual.
The flash is very bright to
my eyes. Do I need to wear
goggles?
The results of the
treatment are not
satisfactory.
Possible cause
The attachment is not
attached properly.
The light intensity setting you
use is too high.
You did not remove the hairs
on the areas to be treated.
The UV filter of the light exit
window is broken.
You treated an area for which
the device is not intended.
This is normal.
You have used a light
intensity setting which is too
high for you.
No, Philips Lumea does not
hurt your eyes.
You have used a light
intensity setting which is too
low for you.
You did not flash an area
adjacent to an area you
treated before.
Solution
Make sure you attach the attachment
completely. If necessary clean the
electronic contacts on the attachment.
Check if you have selected the right light
intensity setting. If necessary, select a
lower setting.
Pretreat your skin before you use Lumea.
If the UV filter is broken, do not use the
device anymore. Contact the Consumer
Care Center in your country, your Philips
dealer or a Philips service center.
Never use the device on the following
areas: inner labia, anus, nipples, areolas,
lips, moles, freckles, tattoos,
piercings. inside the nostrils and ears,
around the eyes and near the eyebrows.
Men must not use it on the face and
neck including all beard growing areas
and whole genital area.
No action required: there is no filter in
the body and armpit attachments. Only
the facial, precision and bikini
attachments have a specialized filter.
Select a lower intensity next
time. See chapter 'Using your Philips
Lumea', section 'Selecting the right light
intensity'.
The scattered light produced by the
device is harmless to your eyes. Do not
look at the flash while using the device. It
is not necessary to wear goggles during
use. Use the device in a well-lit room so
that the light is less glaring to your eyes.
Be sure to make good skin contact to
avoid scattered light.
Select a higher setting next time.
You have to release the flashes close to
each other and there should be some
overlap between the flashes.
29
English