Table of Contents
Advertisement
B.1
Introduction
This section details the steps needed to install various hardware components for the
EPIC-ADS7-PUC. It is recommended that you read through each step before
beginning installation and to make sure you have all necessary tools and components.
B.2
CPU Installation
Step 1: Remove the two (2) screws located on the rear I/O side of the chassis, as shown.
Step 2: Remove the top cover of the chassis by sliding it towards the rear I/O side,
keeping the chassis cover flat throughout.
Note: Do not attempt to remove chassis by pulling it upwards.
Appendix B – Assembly Guide
97
Advertisement
Table of Contents
