Related Manuals for FastTt P5 3T Aduro
Summary of Contents for FastTt P5 3T Aduro
- Page 1 [Designed for Speed] P5 3T Aduro Adapter Kit INSTALLATION GUIDE www.FastTT.bike FastTT P5 3T Aduro Adapter Kit Installation Guide www.fastTT.bike...
- Page 2 There is one left side and one right side adapter stack in each pack. Each adapter stack includes the following components: FastTT adjustable angled risers provide a wide range of bar angle adjustment from 10° to 25°. FastTT P5 3T Aduro Adapter Kit Installation Guide...
- Page 3 INCREASING STACK HEIGHT WITH SPACERS If you are adding FastTT spacers, these should be placed between the adjustable angled riser and the adapter spacer. In this case the round locator domes should be filed off the uppermost spacer ONLY. Do not file off the locator domes on the spacers mounted below the top spacer as this will compromise alignment.
-
Page 4: Installation
Place the adapter stack onto the base bar and ensure that the shifter cable is tucked into the channel on the underside and that it is not pinched. The shifter cable should exit the inside edge. FastTT P5 3T Aduro Adapter Kit Installation Guide www.fastTT.bike... - Page 5 Once both mounting stacks are fitted, you can install your bars and shifters. Start by bolting on the mounting brackets supplied with your bars. At this stage you will need to follow the installation instructions for mounting your FastTT aero bars that are provided in the aero bar installation guide.
- Page 6 Before tightening, check that the shifter cables are not pinched. Tighten both bolts to 5Nm maximum. Tuck the shifter cables into the channels at the rear of the riser blocks. FastTT P5 3T Aduro Adapter Kit Installation Guide www.fastTT.bike...
-
Page 7: Bolt Torque
MUST ALWAYS be installed with the supplied washer. Reinstall the bars and tighten the bar mounting bolts to 5Nm. BOLT TORQUE The following shows the MAXIMUM tightening torque for each bolt. DO NOT exceed these torque ratings: FastTT P5 3T Aduro Adapter Kit Installation Guide www.fastTT.bike... -
Page 8: Warranty
The manufacturer (Bold Horizon Ltd t/a FastTT) assumes no responsibility or liability for any injury, loss or damage caused as a result of using this product under any conditions. FastTT adjustable angled risers are supplied with a 24-month manufacturers defect warranty. Any damage caused by misuse, incorrect installation, modification, accident, or any other cause is not covered by the manufacturer’s warranty.