Fault Message After A Programme Has Been Interrupted - Miele WCE 330 PWash 2.0 Operating Instructions Manual

Problem solving guide

Fault message after a programme has been interrupted.

Problem

Drainage See 

Water intake See


Waterproof system.
Turn off   Ser-
vice

 Service Fault F
To switch off the fault message: Turn the programme selector to the  position
and switch the washing machine off.
54
Cause and remedy
The water outlet is blocked or restricted.
The drain hose has been fixed too high.
 Clean the drain filter and the drain pump.
 The maximum delivery head is 1 m.
The water inlet is blocked or restricted.
 Check whether the stopcock has been properly
opened.
 Check whether the inlet hose is kinked.
 Check whether there is sufficient water pressure.
The filter in the water inlet is blocked.
 Clean the filter.
The drain pump is activated for 2 minutes. The wash-
ing machine door is then released. Wait for the drain
pump to stop before switching the machine off.
The water protection system has reacted.
 Close the stopcock.
 Call Miele.
There is a fault.
 Disconnect the washing machine from the mains
electricity supply, either by switching it off at the
wall socket and withdrawing the plug, or by dis-
connecting it at the circuit breaker.
 Wait at least 2 minutes before reconnecting the
washing machine to the mains electricity supply.
 Then switch the washing machine on again.
 Restart the programme.
If the fault message appears again, contact Miele.