Removing From Storage; Accessories - Toro Recycler 20779 Operator's Manual

1. Loosen the knobs that secure the upper handle.
2. Carefully swing the upper handle forward until it rests
on the engine (Fig. 28).
Figure 28

Removing From Storage

1. Carefully unfold the upper handle until it nests with
the lower handle, then tighten the knobs.
IMPORTANT:
Be extremely careful when unfolding
the handle so that you do not pull, crimp, or in any way
damage the control cables.
2. Check and tighten all fasteners.
3. Remove the spark plug (Fig. 7) and spin the engine
rapidly using the starter to remove the excess oil from
the cylinder.
4. Clean the spark plug or replace it if it is cracked,
broken, or if the electrodes are worn.
5. Install the spark plug and torque it to 15 ft-lb
(20 N m).
6. Perform the recommended maintenance procedures;
refer to Maintenance on page 15.
7. Fill the fuel tank (Fig. 7) with fresh gasoline.
8. Check the engine oil level. Refer to Checking the
Engine Oil Level on page 16.
9. Install the wire onto the spark plug.

Accessories

You may purchase the following accessories from your
Authorized Service Dealer:
Side Discharge Kit
Spark Arrestor
Dethatcher Kit
m–4217
23