Operation And Functions - Klarstein DRYFY 20 Manual

EN

OPERATION AND FUNCTIONS

Timing off
When the dehumidifier is running, press "Timer" to start the function, then press
"Humidity setting" button to set hours, timing range is from 1 to 24hours, it will increase
1 hour by each press. When time is up to your setting, unit will turn off. After the setting is
completed, if the Timer key does not act at all within 5s, the set time is confirmed.
Timing on
When the dehumidifier is in standby state, press "Timer" to start the function, then press
"Humidity setting" button to set hours. When time is up to your setting, unit will turn on.
After the setting is completed, if the Timer key does not act at all within 5s, the set time is
confirmed.
Auto dehumidifying mode
If the humidity in the room is above 5 % of the set humidity, the compressor and fan start.
If the humidity in the room is less than 5 % of the set humidity, the compressor stops and
the fan runs again at the preset speed. When the humidity decreases or increases, the
compressor and fan start and stop alternately. The preset humidity is 50 %.
Cloth dry mode
Under this mode, the unit will work regardless of the room humidity, compressor works,
and fan will work from high speed, fan speed is adjustable.
Start Internal Drying Function
Press the [Drying key in dehumidifier] for over 2s to start drying in the dehumidifier, and
the whole drying procedure needs approximate 1h. The dehumidifier starts at HIGH air
speed and releases air continuously for 30min. The dehumidifier turns to run at LOW air
speed and lasts for 15min.
Stop Internal Drying Function
To stop drying press the Drying button again to cancel and return to running state before
the drying.
20