Control Panel And Button Functions - Klarstein DRYFY 60 SMART Manual

EN
26

CONTROL PANEL AND BUTTON FUNCTIONS

Display
• When the device is connected to the mains, the display shows the
humidity in the room.
• When you set the humidity, the display will show the humidity you
have selected.
• If you program the time for switching the device on and off, the
display will show the time.
• If the humidity in the environment is below 20%, the display will
show 20.
• If the humidity in the environment is above 90%, the display will
show 90.
POWER (device on/off)
When the device is turned on, the light above the power button will
turn on. The power button itself lights up for 3 seconds and then
goes off again. Press the power button to start the device. The device
defaults to free-run mode at 50% power and low wind speed. If there is
a power failure, the device will work in the previously used mode with
the previously used wind speed after turning it on again. If no mode is
set, the next time the device is switched on, it will start again by default
with 50% power and low wind speed.
FAN SPEED (wind speed)
Press the wind speed button to set the wind speeds to HIGH or LOW.
The corresponding indicator light comes on. Press the arrow keys
to enter free dehumidification mode. The humidity can now be set
between 35-80%. Each time you press the button, the setting changes
by 5% RH.