Advertisement
Diameter Dendrometer Large – Type DD-L1
1. Introduction
Thank you for purchasing an Ecomatik Dendrometer type DD-L1. This is a highly precise
sensor for continuous measurements of diameter changes of tree stems/ branches under
outdoor conditions.
This manual is written to help you install and operate your DD-L1 dendrometer with least
difficulty and for desirable results. Please read it carefully before installing the sensor, and
refer to it if you should have any difficulty with the sensor in the future.
The dendrometer is the sensor part of a measuring system. This means that the dendrom-
eter should be connected to a data logger for continuous data recording. The dendrometer
is compatible with the most data logger types. At Ecomatik a low-cost, special for den-
drometers developed DL18 logger is available
2. Product Description
As shown below, the DD-L1 dendrometer consists of:
1 Sensor with 5 m cable. The cable length is extendable to 100 m
1 Frame for fixing the sensor onto the stem/branch
1 Piece UV-resistant perforated rubber belt
Please contact us should you miss anything of these items.
The standard cable length is 5 m. if you ordered cable extension, the cable length is the
ordered extension + 5 m.
To meet the requirements of different loggers, there are 2 different types of cables: cable
with plug and cable without plug. Cable with plug can only be connected to Dendrome-
ter Logger DL18. Cable without plug can be connected to other loggers.
DD-L1 Dendrometer
1
Advertisement
