This manual is written to help you install and operate your DD-L2 dendrometer with least difficulty and for desirable results. Please read it carefully before installing the sensor, and refer to it if you should have any difficulty with the sensor in the future.
Diameter Dendrometer Large – Type DD-L2 4. Installation 4.1 Cable Extension The standard version is delivered with 5 m cable. It can be extended up to 100 m. Cable type 4×0.25 mm with shield is recommended for extensions 4.2 Required tools for installation and for operation A spanner (M3), a pair of scissors .
Page 4
Diameter Dendrometer Large – Type DD-L2 5. Wiring and Logger Configuration The dendrometer is compatible with most data loggers. In the following we describe the connection with Dendrometer Logger (DL18), Campbell Logger (CR1000). Please contact us if your logger is not described here.
Diameter Dendrometer Large – Type DD-L2 6. Adjustment and maintenance Ensure that no falling branches, fruits or snow land on the sensor. The sensor is protected against water droplets but is not waterproof. When the sensor is correctly installed, it will function under outdoor conditions without the need for further maintenance.