Advertisement
Fruit Dendrometer – Type DF2
1. Introduction
Thank you for purchasing an Ecomatik Dendrometer type DF2. This is a highly precise sensor
for continuous measurements of diameter changes of fruits and vegetables under both indoor
and outdoor conditions.
This manual is written to help you install and operate your DF2 dendrometer with least difficul-
ty and for desirable results. Please read it carefully before installing the sensor, and refer to it if
you should have any difficulty with the sensor in the future.
The dendrometer is the sensor part of a measuring system. This means that the dendrometer
must be connected to a data logger for continuous data recording. The dendrometer is com-
patible with the most data logger types. At Ecomatik a low-cost, special for dendrometers de-
veloped DL18 logger is available.
2. Product Description
The picture below shows the contents of delivery. Please contact us should you miss anything
of these items.
The standard cable length is 5 m. if you ordered cable extension, the cable length is the or-
dered extension + 5 m.
To meet the requirements of different loggers, there are 2 different types of cables: cable with
plug and cable without plug. Cable with plug can only be connected to Dendrometer Logger
DL18. Cable without plug can be connected to other loggers.
3. Safety Information
The sensor is protected from rain water, but it is not waterproof. Please do not immerse the
sensor in water, or install the sensor below a longer lasting snow cover.
Fruit Dendrometer
1
Advertisement
