Table of Contents
Advertisement
Fault
The laundry is too
damp.
Fan noise during the
washing phase.
The programme dura-
tion changes during
the wash cycle.
Drum jerks after the
programme starts.
Cause and troubleshooting
Drying target not adjusted.
Load too small.
Moisture sensor dirty.
Water tap is closed during the drying phase.
Make sure that the water tap also remains open
▶
during the drying phase.
The ambient temperature is greater than 30 °C.
Ensure that the ambient temperature is lower than
▶
30 °C.
Insufficient air circulation at the appliance's installation
location.
Ventilate the appliance's installation location.
▶
The water pressure is low.
No remedial action possible.
Laundry is not spun sufficiently.
Always select the highest possible spin speed for
▶
the washing programme in question.
Thick and multi-layered fabrics require a longer drying
time.
Set a timed programme for the subsequent drying.
▶
→ "Programmes", Page 25
Process fan is active.
Not a fault – normal operating noise.
▶
The programme operation is optimised electronically.
This may change the programme duration.
Not a fault – no action required.
▶
The unbalanced load detection system eliminates an
imbalance by repeatedly redistributing the laundry.
Not a fault – no action required.
▶
Note: When loading, where possible, place large and
small items of laundry together in the drum. Different
sized items of laundry distribute themselves better
during the spin cycle.
Foam detection system switches on a rinse cycle if
foam build-up is too high.
Not a fault – no action required.
▶
This is caused by an internal motor test.
Not a fault – no action required.
▶
Troubleshooting en
45
Advertisement
Table of Contents
