Table of Contents
Advertisement
en Troubleshooting
Fault
Detergent residue on
the damp washing.
Detergent residue on
the dry laundry.
Water is leaking out at
the water inlet hose.
Water is leaking out at
the water outlet hose.
Fluff on the laundry.
Water inlet noise dur-
ing the drying phase.
Drying programme
does not start.
The laundry is too
damp.
44
Cause and troubleshooting
Detergents may contain water-insoluble substances
that deposit on the laundry.
Start the Rinse
▶
Detergents may contain water-insoluble substances
that deposit on the laundry.
Brush out the laundry after washing and drying.
▶
Water inlet hose is not correctly/securely connected.
Connect the water supply hose correctly.
1.
→ "Connecting the water inlet hose", Page 15
Tighten the screw connection.
2.
The water outlet hose is damaged.
Replace the damaged water outlet hose.
▶
Water outlet hose is not connected correctly.
Connect the water outlet hose correctly.
▶
→ "Water outlet connection types", Page 16
Fluff has accumulated in the drum.
Run the Cottons 90℃ programme without any laun-
▶
dry or detergent.
Drying phase requires water.
Not a fault.
1.
Make sure that the water tap also remains open
2.
during the drying phase.
Door is not closed.
Close the door.
1.
Press
Start/Reload to start the programme.
2.
No drying programme is selected.
Select a suitable drying programme.
▶
→ "Programmes", Page 25
Unsuitable programme for the type of fabric.
There has been a power cut.
Check whether the lighting in your kitchen or other
▶
appliances are working.
The load is too large.
After the end of the programme, warm laundry feels
damper than it actually is.
Remove the laundry from the drum as soon as the
1.
drying programme has finished.
Spread the items of laundry for cooling.
2.
Unsuitable dryness level set.
programme.
Advertisement
Table of Contents
