Get Started; Charge The Battery; Pair The Headphones With Your Mobile Phone - Philips PN402 User Manual

3 Get started

Charge the battery

Note
 Before you use your headphone for the rst
time, place the headphones in the charging
case and charge the battery for 3 hours for
optimum battery capacity and lifetime.
 Use only the original USB charging cable to
avoid any damage.
 Finish your call before charging the
headphone, as connecting the headphone for
charging will power the headphone o .
Charging case
Connect the supplied USB charging
cable to:
• The micro USB charging slot on the
headphones and;
• The charger/USB port of a
computer.
LED turns red during charging and
turns o when the headphones in
fully charged.
Tip
 Normally, a full charge takes 2 hours.
Pair the headphones
with your mobile phone
Before you use the headphones with
your mobile phone for the rst time, pair
it with a mobile phone. A successful
pairing establishes a unique encrypted
link between the headphones and
mobile phone. The headphones store
the last 8 devices in the memory. If you
try to pair more than 8 devices, the
earliest paired device is replaced by the
new one.
Make sure that the headphones are
fully charged and turned o .
Press and hold
until the blue and red LED ashes
alternately.
The headphone remain in
pairing mode for 2 minutes.
Make sure that the mobile phone is
turned on and its Bluetooth feature
is activated.
Pair the headphones with the
mobile phone. For detailed infor-
mation, refer to the user manual of
your mobile phone.
The following example shows you how
to pair the headphones with your mobile
phone.
Activate the Bluetooth feature of your
mobile phone, select Philips PN402
Enter the headphone password
"0000" (4 zeros) if prompted. For
those mobile phones featuring
Bluetooth 3.0 or higher, no need to
enter a password.
Philips PN402
for 5 seconds