Ignition Switch; Keyless Push Button Ignition - Alfa Romeo Giulia 2024 Owner's Manual

CAUTION!
The Engine Immobilizer system is not compatible with
some aftermarket Remote Start systems. Use of
these systems may result in vehicle starting
problems and loss of security protection.
All of the key fobs provided with your new vehicle have
been programmed to the vehicle electronics.
NOTE:
A key fob that has not been programmed is also
considered an invalid key page 316.

IGNITION SWITCH

K P B I
EYLESS USH UTTON GNITION
This feature allows the driver to operate the ignition
switch with the push of a button as long as the key fob
is in the passenger compartment.
The START/STOP ignition button has several operating
modes. These modes are OFF, ACC, and ON/RUN.
START/STOP Ignition Button
The push button ignition can be placed in the following
modes:
OFF
□
The engine is stopped
□
Steering is locked
□
Some electrical devices (e.g. central locking, alarm,
etc.) are still available
ACC
□
Engine is not started
□
Some electrical devices are available (e.g. power
sunroof, power windows, etc.)
ON/RUN
□
The engine will start (when foot is on the brake
pedal)
□
All electrical devices are available (e.g. climate
controls, etc.)
If the ignition switch does not change the mode by
pushing the button, the key fob may have a low or
depleted battery. In this situation, a backup method
can be used to operate the ignition switch. Proceed as
follows:
1. Lift the front armrest.
2. Lay the key fob on the indicated spot in the bottom
of the center console, positioning the key fob as
shown in the following image, while pushing the
START/STOP ignition button to start the ignition.
Key Fob Placement Location
NOTE:
□
For more information on proper engine starting
procedures, see page 85.
□
With the keyless ignition in the ACC position, if
30 minutes pass with the gear selector in PARK and
the engine off, the ignition will automatically reset to
the OFF position.
□
When opening the driver's door with the ignition in
the ACC position (engine not running), a chime will
sound to remind you to place the ignition in the OFF
position. In addition to the chime, the message will
display "Ignition Or Accessory On" in the cluster.
27