4. Alignment and Troubleshooting
4.1.8. Tech Mode (Diagnostic Mode)
In service (tech) mode, the technician can check the machine and perform various test to isolate the cause of a malfunction.
While in Tech mode, the machine still performs all normal operations.
1) Entering Tech Mode
•
Press "Menu > Back > Left > Right > OK > Stop" on the control panel continuously.
2) Tech Mode Menu
NOTE
Some menu items may not appear on the display depending on the options or models.
Depth 1
Depth 2
Tech Mode
Data Setup
Report
EDC Mode
NVM Read Write
NVM Initialize
Test Routines
3) Data Setup
•
Counter Reset
This function resets the count value you select.
•
Clear All Memory
The function resets the system to factory default settings. This function is used to reset the system to the initial value
when the product is functioning abnormally . All the values are returned to the default values, and all the information,
which was set by the user, will be erased.
NOTE
Always perform a memory clear after replacing the main board. Otherwise, the system may not operate properly.
•
Toner Low Level
4-19
Depth 3
Depth 4
Counter Reset
Fuser
Pickup Roller
Clear All Mem.
[Country list]
B2B Mode
0-99
Toner Low Level
[1~30]: 10 %*
Suppilies Info
Printing...
Configuration
Printing...
Usage Counter
Printing...
Job Duty
Printing...
Error Info
Printing...
Auto Color Reg
Printing...
Auto Toning
Printing...
Initialize Now
Copyright© 1995-2017 SAMSUNG. All rights reserved.
Depth 5
Tray1
Tray2
MP Tray