Table of Contents
Advertisement
SYMBOLOGY
V
Volts
Direct Current
No Load Revolutions per Minute (RPM)
Blows per Minute Under Load (BPM)
AutoSTOP™
Read operator's manual.
Regulatory Compliance Mark (RCM).
This
regulatory requirements.
Do not dispose of electric tools
together
material. Electric tools and electronic
equipment that have reached the end
of
their
separately
environmentally compatible recycling
facility.
FUNCTIONAL DESCRIPTION
3
2
1
11
10
9
8
1. Keyless chuck
2. Torque selector collar
3. Speed selector
4. Side handle
5. Control switch
6. Handle
ASSEMBLY
Recharge only with the charger
WARNING
specified for the battery. For
specific
charging
operator's manual supplied with your charger
and battery.
product
meets
with
household
life
must
be
and
returned
5
4
7. Belt hook
8. LED
9. Mode selector
10. Bit holder
11. Trigger
instructions,
read
Inserting/Removing the Battery
To insert the battery, slide the pack into the body
of the tool. Make sure it latches securely into place.
To remove the battery, push in the release buttons
and pull the battery pack away from the tool.
WARNING
is not in use.
WARNING
may be hazardous.
To reduce the risk of injury, always use a side
handle when using this tool. Always brace or
hold securely. Ensure side handle is tightened
securely before each use.
1. To install the side handle,
applicable
loosen the side handle
grip until the hooks are far
slots on the gear case
waste
ring. Position the side
handle on the top, pointing
to the left or right. Tighten
collected
the side handle grip until
to
an
it is secure.
2. To r e m o v e t h e s i d e
handle, loosen the side
handle grip until the side handle can be removed.
Reposition and tighten securely.
Correct
WARNING
accessories. Only use accessories specifically
6
recommended for this tool. Others may be
hazardous.
Always remove
7
ing bits. Select
This
tool is
can be tightened with one hand, creating
strengths on
To open the chuck jaws, turn the sleeve in the
1.
anticlockwise direction. When using drill bits,
allow the bit to strike the bottom of the chuck.
Centre the bit in the chuck jaws and lift it about
1.5 mm off of the bottom.
2. To close the chuck jaws, turn the sleeve in the
clockwise direction. The bit is secure when the
chuck makes a ratcheting sound and the sleeve
can not be rotated any further.
To remove the bit, turn the sleeve in the
3.
anticlockwise direction.
NOTE: A ratcheting sound may be heard when the
chuck is opened or closed. This noise is part of the
the
locking feature, and does not indicate a problem with
the chuck's operation.
4
Always lock the trigger or remove
the battery pack
Only use
accessorie
reco
mmended
Installing the Side Handle
Slots
Always remove battery pack
before changing or removing
Installing Bits
the battery before inserting
the proper style and size bit
equipped with a spindle lock.
the bit.
any time the tool
s
for thi
s tool. Others
Hooks
Incorrect
or
remov-
for the job.
The
chuck
higher grip
Advertisement
Table of Contents
