Frigidaire FDPC4314AS Use & Care Manual page 15

Care of Drain Air Gap
If a drain air gap was installed for your
built-in dishwasher, check to make sure
it is clean so the dishwasher will drain
properly. A drain air gap is usually
mounted on countertop and can be
inspected by removing the cover. This
is not part of your dishwasher and is not
covered by warranty.
Winterizing
A dishwasher left in an unheated place
should be protected from freezing. Have
a qualified person do the following:
To Disconnect Service:
1. Turn off electrical power to the
dishwasher at the supply source by
removing fuses or tripping circuit
breaker.
2. Shut off water supply.
3. Place a pan under the inlet valve.
Disconnect water line from inlet
valve and drain into pan.
4. Disconnect drain line from pump
and drain water into pan.
To Restore Service:
1. Reconnect the water, drain, and
electrical power supply.
2. Turn on water and electrical power
supply
3. Fill both detergent cups and run
dishwasher through a HEAVY WASH
cycle.
4. Check connections to make sure
they do not leak.

NOTE
See Installation Instructions for more
details on disconnecting and restoring
service to your dishwasher.
CARE AND CLEANING
15