Installing Hard Disk Drives; Setting The Raid Item In Bios - Asus P11C-X User Manual

5.1.2

Installing hard disk drives

The motherboard supports Serial ATA for RAID set configuration. For optimal performance,
install identical drives of the same model and capacity when creating a disk array.
To install the SATA hard disks for RAID configuration:
1. Install the SATA hard disks into the drive bays following the instructions in the system
user guide.
2. Connect a SATA signal cable to the signal connector at the back of each drive and to
the SATA connector on the motherboard.
3. Connect a SATA power cable to the power connector on each drive.
5.1.3

Setting the RAID item in BIOS

You must set the RAID item in the BIOS Setup before you can create a RAID set from SATA
hard disk drives attached to the SATA connectors supported by Intel
To do this:
1. Enter the BIOS Setup during POST.
2. Go to the Chipset Menu > PCH-IO Configuration > SATA And RSTe Configuration,
then press <Enter>.
3. Set SATA Mode to [RAID].
4. Press <F10> to save your changes and exit the BIOS Setup.
Refer to Chapter 4 for details on entering and navigating through the BIOS Setup.
P11C-X
C242 chipset.
®
5-3