Troubleshooting - Profi Cook PC-GG 1058 Instruction Manual

Table of Contents

Available languages

Switching on the side burner

You can operate the side burner separately.

1. Open the cover of the side burner before you ignite it.

2. Press the adjustable knob of the burner and turn it anticlockwise to the HI position. At the same time, you will hear a CLICK. The burner will ignite. If the

burner does not ignite, repeat this step.

3. If the burner still does not ignite, wait 5 minutes and repeat step 2.

4. If the burner does not ignite, ignite the burner with a long match. Contact your dealer or gas technician in order to resolve the fault with the ignition.

5. Regulate the heat by turning the adjustable knob to any setting of your choice between the HI and LOW setting.

6. In order to shut down the burner, turn the adjustment knob to the 12 o'clock position (OFF).

7. In order to shut down the entire barbecue, close the valve on the gas cylinder and turn all the adjustment knobs to the 12 o'clock position (OFF).

Head distribution on the grille

As a result of the design of burner, the heat distribution is specified as follows:

Tips for barbecue cooking

The gas barbecue is a multifunctional appliance. With the hood closed, you can use your gas barbecue like an oven.

• You don't have to only barbecue meat, fish, vegetables and fruit, you can also cook them.

• With a closed hood, the temperature should not be allowed to get too high. A low temperature results in gentle cooking of the barbecue food.

• Monitor the temperature on the thermometer and if necessary, adjust it.

• The following applies as a rule of thumb: If smoke emerges from a closed hood, the temperature is too high!

Malfunctions are often just caused due to minor problems. Before contacting our customer service, please check the table below:

Problem

Possible cause

The burners cannot be ignited

1 Gas cylinder is empty

by the ignition system.

2. The regulator is damaged

3. The burner is blocked

4. The gas jets or hose is blocked

5. The electrode wiring is loose or separated from the elec-

6. The electrode or cable is damaged, faulty switch ignition

Burner does not ignite with a

1. Gas cylinder is empty

lit match

2. The regulator is damaged

3. The burner is blocked

4. The gas jets or hose is blocked

No yellow flame or back cou-

1. Gas cylinder is too small

pling (fire in the burner line –

2. Burner blocked (insect nest?)

hissing or bubbling noise)

3. The gas jets or hose is blocked

4. Draft