Location And Connection - EUROM 334241 Instruction Manual

Patioheater quarz
Hide thumbs Also See for 334241:
Table of Contents

Advertisement

Available languages
  • EN

Available languages

  • ENGLISH, page 19
Description
1. Heating element (2x) quartz
2. Peep hole
3. Pull switch

Location and connection

Remove all packaging material and keep out of reach of children. Pay attention
to the mounting material!
After removing packaging, check the appliance for damage or other signs that
could indicate a fault/defect/malfunction. In case of doubt, do not use the
appliance, but contact your vendor for inspection or replacement.
Select a suitable location for the device taking into account all the
aforementioned warnings in this manual.
This heater has been designed to be hung horizontally from a wall; therefore do
not use it whilst it is standing, lying or in any other way!
Pay attention to the mounting place for your heater. The appliance has to be
mounted on an incombustible foundation. That foundation has to be vibration free,
exact vertical and stable enough for lastingly holding the appliance free of
problems. Check or the provided dowels and screws are suitable, strong enough
and qualified for the foundation. The material provided is identified for a brick
wall; for another foundation please ask the specialist for suitable material.
Check before mounting or the minimum safe mounting distances between heater
and environment are strictly followed. The distance between the bottom edge of
the appliance and the floor must be at least 1,8 meter. There must be a distance
of at least 0,5 meter between the appliance and the ceiling, roof or other cover.
If the covers consist of flammable material (p.e. wood, plaster, canvas etc.), the
distance has to be at least 1 meter and if you focus the radiator upwards, at least
2 meter. There must be a distance of at least 1,5 meter at each side between the
appliance and walls or the like. When you install the appliance outside, pay
attention that it doesn't catch excessive wind load.
The insulation of the Q-Time 2001 is IP24 rated (splash proof). A distance of at
least 1 m has to be maintained between the heater and baths, taps, fountains,
showers etc. Make sure that no jets of water can be directed at the Q-Time 2001
and that the heater cannot fall into the water.
23

Advertisement

Table of Contents
loading

This manual is also suitable for:

Q-time 2001

Table of Contents