Table of Contents
Advertisement
Building in the appliance
^ Align depth "Z" on the furniture door:
Loosen the screws in the long slots at
the top c and bottom d of the
appliance door. By moving the
furniture door, create a gap of 2 mm
between the furniture door and the
front edge of the niche. Align it to
match the neighbouring furniture
doors.
^ Close plastic brackets a again.
^ Close the door and align it with
neighbouring furniture doors.
^ Tighten all screws again.
^ Place the cover in position.
44
To make sure the appliance is
correctly fitted:
– The door must close properly.
– The door must not touch the furniture
carcase.
– The seal at the top edge of the
handle side must fit properly.
To double check, place a torch in the
appliance and close the door.
Turn the lights out in the room. If you
can see any light shining out from the
sides double check the installation.
Advertisement
Table of Contents
