Defrosting; Maintenance And Cleaning - Tefcold UHD 200-P User Manual

Press this key to scroll down through the parameter-list.
Press this key to select the parameter to change, the display will show the actual value, use
the up/down keys to change the value and confirm with 'Set':
The display will return to normal reading after 15 sec.
See table of parameters from page 44.
Alarm codes:
AH1 Flashing in the display: indicates that the cabinet temperature is too high.
AL1 Flashing in the display: indicates that the cabinet temperature is too low.

Defrosting

The cabinet defrosts automatically with pre-set intervals.
If it may become necessary to defrost the cabinet manually, this can be started by pressing the 'Up'-
key continuosly for more than 5 seconds.
Defrosted water runs to a container placed in the compressor compartment and evaporates.

Maintenance and cleaning

Switch the cooler off at the socket.
The cabinet must be periodically cleaned. Clean the external and internal surfaces of the cabinet
with a light soap solution and subsequently wipe dry.
Do NOT use cleansers containing chlorine or other harsh cleansers, as these can damage the
stainless steel surfaces and the internal cooling system.
Clean the condenser and the compressor compartment using a vacuum cleaner and a stiff brush.
Do NOT hose the compressor compartment with water as this can cause short circuits and damage
on the electrical parts.
17