Table of Contents
Advertisement
Before using for the first time
2. Remove the transit bars
Failure to remove the transit bars
can result in damage to the washing
machine and to adjacent cabinetry or
appliances.
Remove the transit bars as described
in "Installation and connection".
The following message appears in the
display:
Remove transit bars
Confirm with the OK sensor.
3. Start the calibration pro-
gramme
For optimum water and energy con-
sumption and excellent wash results, it
is important to calibrate the washing
machine.
To do this, the Cottons programme
must be run without laundry and
without detergent.
No other programmes can be started
until calibration has been carried out.
The following message appears in the
display:
Open and run "Cottons" 90°C without
laundry.
Touch the sensor until the OK
sensor lights up and confirm this with
OK.
90°
1600
Open the stopcock.
Touch the Start/Stop sensor.
18
The calibration programme then starts.
It will take approximately 2 hours.
At the end of the programme the follow-
ing message will appear in the display:
Reach under the door grip and pull
Tip: Leave the door slightly open to al-
low the drum to dry.
Turn the programme selector to the
1:55
OK
Set up complete
the door open.
position.
Advertisement
Table of Contents
