Advertisement
Quick Links
USER MANUAL
ORIGINAL USER MANUAL.
SKU: 0458-395-0841
REV: 1
18 / 23 HP PETROL ENGINE
information on assembly, settings and safety instructions.
Read through the user manual carefully and make
sure you understand its contents before using the saw.
BRIGGS & STRATTON
This manual describes installation of the petrol
engine for the Logosol band sawmill.
Please see the user manual for your band sawmill for
EN
EN
Advertisement
Related Manuals for Logosol 0458-395-0841
Summary of Contents for Logosol 0458-395-0841
- Page 1 18 / 23 HP PETROL ENGINE BRIGGS & STRATTON This manual describes installation of the petrol engine for the Logosol band sawmill. Please see the user manual for your band sawmill for information on assembly, settings and safety instructions. Read through the user manual carefully and make...
- Page 2 PACK SUPPLIED 8200-000-0054 / 55 8200-000-0056 8400-000-0067 8200-000-0069 18 hp petrol engine Silencer and manifold, Petrol-powered Electric start (excl / incl electric start) 18 hp 18/23 hp 18/23 hp Briggs & Stratton 8050-000-0070 8050-000-0071 23 hp petrol engine Silencer and manifold, Briggs &...
- Page 3 18 / 23 HP PETROL ENGINE WARNING! Heavy! Risk of injury. WARNING! Risk of entrapment. Wear protective gloves and handle the engine Two people are always required to help with carefully when placing it down on the engine shelf. heavy lifting. INSTALLATION: ENGINE AND THROTTLE CABLE The engine has to be installed on the engine shelf and secured using the fastening screws.
- Page 4 Mount the centrifugal clutch on the shaft, securing the clutch using the key. 1 x – 9021-014-0003 1 x – 3/8UNFx32 1 x – SRKB11x35x2 4 x – 03-02448 1 x – 03-02053 Thread the drive belt around the drive wheel and over the tensioner.
- Page 5 18 / 23 HP PETROL ENGINE Release the valve cover fastening screws, then remove the valve cover from the engine. This has to be done in order to access the upper throttle control bracket, which is sited beneath the lower right corner of the valve cover: see Figure 8.
- Page 6 WARNING! Risk of serious injury. WARNING! Risk of burn injuries. The engine and its silencer become very hot during operation and after the engine has been Before adjusting the throttle cable tension on shut down. the engine: Turn the ignition to OFF and close the fuel valve.
- Page 7 The installation is correct if the engine does not start when the key is turned. Switch off the engine from the operator’s station if the engine starts with the cover open. Then double-check the connection and contact Logosol for support.
- Page 8 INSTALLATION: ELECTRIC START If the engine option comes with electric starting, this is connected as described: Start by taking the connector with the red cable and plugging it into the engine (1). The cable is packaged together with the user manual for the engine. Then connect it to the plug/+ cable (2).
-
Page 9: Setup Sequence
18 / 23 HP PETROL ENGINE Well done! Now you have finished installing the engine, go back to the manual for your band sawmill and carry on with the setup sequence, starting at the point as indicated in the instructions below. SETUP SEQUENCE Read through all the set-up instructions before starting to set up, then follow the instructions step by step as you work. - Page 12 Fiskaregatan 2, SE-871 33 Härnösand, Sweden 0611-182 85 | info@logosol.se | www.logosol.se...