INSIGHT DLP DIRECTOR 1000 Hardware Installation Manual page 11

9. Rear Panel Connections
3 3
Step 1: Connect the Ethernet cables.
Step 2: Connect any other required cables.
Step 3: Connect the power cords.
Step 4: Proceed to Section 10, Front Panel Operation on page 12.
NOTE: The server offers redundant, hot-swap capability. The connections
to AC mains should be made in a manner appropriate to local code and
consistent with customer power distribution with or without redundant
sources.
CAUTION
The power supply is only hot-swappable if you have a redundant system with
two power supplies installed. If you only have one power supply installed,
before removing or replacing the power supply, you must first take the server
out of service, turn off all peripheral devices connected to the system, turn off
the system by pressing the power button, and unplug the AC power cord
from the system or wall outlet.
INSIGHT DLP DIRECTOR 1000 & 2000 Appliance Hardware Installation Guide
(continued)
MGMT MGMT SP SPAN AN DLP DLP eth3 eth3
MGM MGMT T
SP SPAN AN
DLP DLP
eth eth3 3
1 1
eth4 eth4 eth5 eth5 eth6 eth6 eth7 eth7
eth eth4 4
eth eth5 5 eth6 eth 6
eth eth7 7
2 2
www.insightdlp.com Page 11