Quanser QNET 2.0 VTOL Quick Start Manual page 2

STEP 4
Assembly
To assemble the QNET VTOL , please read the following instructions carefully. For full details, see the QNET VTOL User Manual.
A
Remove the four
thumbscrews
located on the
bottom of the
VTOL support.
C
STEP 5
Setup Hardware
A
B
D
24V 2.0A
B
Tighten the four
thumb screws to
secure the arm to
the QNET board.
Place the handle
on the front of
the QNET board
over the bracket
located on the
front of the NI
ELVIS II.
Connect the NI
ELVIS II power
24V 2.0A
External Power
supply to the
back panel of
the NI ELVIS II.
Ensure that the NI ELVIS II power switch is in the OFF position.
C
E
+15V
-15V
+5V
External Power
PC
Bring the support arm into the upright
position and align the screw holes on
the bottom of the support with the
four holes indicated on the bottom of
the QNET board.
D
When assembled,
the system should
resemble the QNET
VTOL shown in Step 1.
Slide the PCI
connector at
the back of
the QNET
board into
the female
connector on
the NI ELVIS II.
Use the NI ELVIS II
USB cable to
+15V
-15V
+5V
connect the NI
ELVIS II unit to
your computer.