Adjusting The Fastening Torque - Makita DHP441 Instruction Manual

NOTE:
• When changing the position from "1" to "3" or
from "3" to "1", it may be a little difficult to slide
the speed change lever. At this time, switch on
and run the tool for a second at the "2" position,
then stop the tool and slide to your desired
position.
CAUTION:
• Always set the speed change lever fully to the
correct position. If you operate the tool with the
speed change lever positioned halfway between
the "1" position, "2" position and "3" position, the
tool may be damaged.
• Do not use the speed change lever while the
tool is running. The tool may be damaged.
Selecting the action mode
1
► 1 . Action mode change lever
This tool employs an action mode change lever. Select
one of the three modes suitable for your work needs by
using this lever.
For rotation only, slide the lever so that it points toward
the mark on the tool body.
For rotation with hammering, slide the lever so that it
points toward the mark on the tool body.
For rotation with clutch, slide the lever so that the it
points toward the mark on the tool body.
NOTE:
• When changing the position from "
" ", it may be a little difficult to slide the mode
change lever. At this time, switch on and run the
tool for a second at the "
the tool and slide to your desired position.
CAUTION:
• Always set the lever correctly to your desired
mode mark. If you operate the tool with the lever
positioned halfway between the mode marks,
the tool may be damaged.
" to
" position, then stop
7 ENGLISH

Adjusting the fastening torque

► 1 . Adjusting ring 2. Arrow 3. Graduations
The fastening torque can be adjusted in 16 steps by
turning the adjusting ring so that its graduations are
aligned with the arrow on the tool body. The fastening
torque is minimum when the number 1 is aligned with
the arrow, and maximum when the number 16 is aligned
with the arrow.
Before actual operation, drive a trial screw into your
material or a piece of duplicate material to deter-
mine which torque level is required for a particular
application.
ASSEMBLY
CAUTION:
• Always be sure that the tool is switched off and
the battery cartridge is removed before carrying
out any work on the tool.
Installing side grip (auxiliary handle)
1
2
► 1 . Steel band 2. Grip base 3. Protrusion 4. Side grip
5. Groove
Always use the side grip to ensure operating safety.
Insert the side grip so that the protrusions on the grip
base fit in between the grooves on the tool barrel. Then
tighten the grip by turning clockwise.
1
3
2
5
3
4