First-Time Operation; Getting Started - Westinghouse WH100P Operation Manual

Main Parts & Components
Illustration Diagram:
Right Air Outlet
NCCO Reactor
Air Inlet
Panel
A B C D E
Control Panel
J
Control Panel:
Reduce Button
Display Screen
*Unit supports 2.4Ghz / 5Ghz Ghz Wifi. If there is any connection problem, please contact your router
supplier for problem solution.
05
Basic Information
HEPA Filter
HEPA Filter Frame
Static Filter
Back
(Optional)
Cover
F G H I
Pre-filter
K
Power Cord L
Power Cord Inlet
M
Power Cord Coupling
Air Speed Air Speed Eco Mode ON / OFF
Increase Button Button Button

First-time Operation

1. Remove all packaging materials, use a soft dry 4. The unit is equipped with a sensor. If filters are
cloth to clean all the parts then re-assemble
parts back together. 5. When the unit is turned on for the first time,
2. Place the unit on a dry, solid, level surface,
and ensure the unit is provided with reasonable
space of at least 15 cm from any objects, in
order to operate effectively.
3. Check power sockets and any extension cords
to confirm compliance with unit requirements.
Ensure that the unit is plugged in before usage.
Installation Procedures:
Disconnect the power supply, hold the two
buckles at the bottom of the Front Cover, to
take off the Front Cover.
First, put Static Filter on HEPA Filter and then
install Static Filter and HEPA Filter into HEPA
Filter Frame. Then, put Pre-filter on HEPA FIlter
Frame.

Getting Started

not installed properly, the unit will not operate.
warm air and mineral smell may be released
from the air outlet. This is normal as catalytic
oxidation is taking place inside the NCCO Reactor,
and completely harmless to human body.
Remove all packaging materials before usage.
Install the upper NCCO Reactor and HEPA
Filter Frame in sequence into unit. A clicking
sound would be heard to indicate a successful
filters installation. The installation steps of the
lower filters are the same as the upper one.
06