Care & Maintenance - Levoit LUH-M101S-WEUR Manual

EN
CARE & MAINTENANCE
Note:
•
All maintenance should be done on a water-
resistant surface.
•
Change the water daily to avoid bacteria
growth.
•
Use a tissue or cloth to clean the nozzle
regularly.
•
If not using the humidifier for 1 week or longer,
do not leave water inside. Clean and dry the
humidifier instead.
Cleaning
You should clean your humidifier water inlet
tank, base chamber, and water tank every 3
days, and when you're ready to store it.
Note:
•
Never immerse the base in water or liquid.
Do not place any part of the humidifier in a
dishwasher.
•
Do not use detergents to clean the humidifier.
1. Unplug the humidifier.
2. Remove and rinse the water tank cover.
[ ]
Figure 6.1
3. Remove the water inlet tank from the
humidifier base. [
4. Pull the mist tube from the narrow end to
remove it. [
Figure 6.3
5. Flip the water inlet tank over and remove
the muffler. [
Figure 6.4
6. Rinse the water inlet tank, mist tube, and
muffler.
7. Remove the humidifier base and pour
out any water. Pour from the corner of
the base chamber to prevent water from
damaging the humidifier. [
8. Use a small brush to clean the base
chamber. Rinse with room-temperature
water.
12
]
Figure 6.2
]
]
]
Figure 6.5
Note: Do not
allow water to contact the
air outlet, aroma box, or underside of the
humidifier base.
9.
Pour out any water in the water tank. Use
a brush to clean the inside of the tank,
then rinse with room-temperature water.
[ ]
Figure 6.6
10. Pull to remove the filter from the silicone
tube. Wash the filter with water and a soft
cloth. [ ]
Figure 6.7
Note: Do not remove the silicone tube from
the water tank.
11. Dry all parts with a cloth. Make sure
all parts are completely dry before
reassembling or storing.
Descaling Your Humidifier
To descale the humidifier (remove mineral
buildup):
1. Remove the humidifier base from the
water tank.
Fill the water tank with 6 US cups / 1,420
2.
mL of distilled white vinegar. [
3. Fill the base chamber with 1 US cup / 240
mL of distilled white vinegar [
4. Carefully swish the vinegar around the
tank and base chamber. Do not allow
liquid to contact the air outlet. [
5. Allow the parts to soak for 15–20
minutes. Vinegar will loosen scale
(mineral buildup) in the tank and base
chamber. [
Figure 7.4
6. Pour out the vinegar. [
Use a soft cloth and cleaning brush to
7.
remove scale from all parts. [
]
Figure 7.1
]
Figure 7.2
]
Figure 7.3
]
]
Figure 6.5
]
Figure 7.5