Kenwood TK-3401D Instruction Manual page 12

The battery pack life is over when its operating time decreases even
◆
though it is fully and correctly charged. Replace the battery pack.
While operating the transceiver using a Li-ion battery pack in areas of
◆
an ambient temperature of –10°C and lower, operating time may be
shortened.
BATTERY LIFE
The operating times listed in the table below are measured
under the following cyclic conditions:
Calculated using 5% transmit time, 5% receive time, and 90%
standby time.
Battery Type
KNB-45L
Supplied battery
KNB-69L
Optional battery
INSTALLING THE BELT CLIP
Do not use glue which is designed to prevent screw loosening when
installing the belt clip, as it may cause damage to the transceiver. Acrylic
ester, which is contained in these glues, may crack the transceiver's back
panel.
4
Digital Mode
Battery Saver
On
16 H
22 H
If necessary, attach the belt clip using
the two supplied M3 x 8 mm screws.
Note:
◆ If the belt clip is not installed, its
mounting location may get hot during
continuous transmission or when left
Belt clip
sitting in a hot environment.
Operating Time/ Hours (Approx.)
Battery Saver Battery Saver
Off
14H
18H
Analog Mode
Battery Saver
On Off
18H 14H
24H 18H