Advertisement
Quick Links
www.sukcesgroup.pl
In order to fully explore available functions of MAGNETIC series please take a moment and read this manual before using the device.
MAGNETIC transmitters are compatible with all YOODA brand devices.
1. General information
Radio receiver range is a variable value and can differ from declared values depending on conditions in which device
operates. Possible sources of changes in range are building construction, interference caused by other radio transmitters
etc.
2. Detailed description
L1 timer programming
button/CHANNEL + button
Work mode button
P1 configuration change
button/CHANNEL -
MAGNETIC_1RwT
|
MAGNETIC_5RwT
1. Control:
can control single motor, or a group
of up to 20 motors on each channel
2. Range:
200 meters outdoor,
35 meters indoor
3. Battery:
1 x CR2430
4. Power supply:
3 V
5. Dimensions:
80 x 80 x 14 mm
6. Transmitting power:
10 mW
7. Operating temperature:
from 0°C to 50°C
8. Protection degree:
IP 30
Illustrations (from the top):
Fig. 1. Single-channel MAGNETIC remote control with timer, (MAGNETIC_1RwT)
Fig. 2. 55-channel MAGNETIC remote control with timer, (MAGNETIC_5RwT)
UP button
Days of the week
STOP button
Minutes
DOWN button
Work mode
1
Discharged
battery message
Direction of roller
shutter movement
Hour
Currently channel
(only 5Rwt)
Advertisement
Related Manuals for YOODA MAGNETIC Series
Summary of Contents for YOODA MAGNETIC Series
- Page 1 MAGNETIC_1RwT MAGNETIC_5RwT www.sukcesgroup.pl In order to fully explore available functions of MAGNETIC series please take a moment and read this manual before using the device. MAGNETIC transmitters are compatible with all YOODA brand devices. 1. General information 1. Control: can control single motor, or a group of up to 20 motors on each channel 2.
- Page 2 1. The programming button replaces the simultaneous pressing of the work mode button and L1 timer programming button. 2. Group channel is active when all numbers are selected 4. Estimated battery lifespan is 3 year if the device runs 4 commends a day in average. 5.
- Page 3 6. Setting automatic opening and closing time 1. Difference between automatic time of roller shutter opening and closing cannot be shorter than 32 minutes. In case of smaller than minimal time difference fault message will appear. 2. Changes to opening and closing time can be done only in automatic mode. 3.
- Page 4 7. Programming first transmitter to R-type motors 1. Way of programming first transmitter depends on type of radio receiver. When programming first transmitter please follow instruction of the device that is going to be controlled by the transmitter. 2. Longer than 5 seconds pause between series of button clicks during programming will cause device to switch off from programming mode without saving any changes.