YOODA MAGNETIC-PRO-15Rw YSH Manual

MAGNETIC_PRO_15Rw YSH
To use the technical capability of MAGNETIC PRO YSH transmitters optimally, read the following instructions carefully. MAGNETIC PRO YSH transmitters
are compatible with all devices of YOODA SMART HOME system.
MAGNETIC PRO YSH transmitters is control dedicated to bidirectional communication.
1. Technical data
MAGNETIC PRO YSH 15-channel remote control with a display, white
(MAGNETIC PRO_15Rw YSH)
The range given by the manufacturer is a variable value, depending on the conditions in the environment in which the device
works. Factors such as building structure, signal interference from other devices, etc. affect range.
2. Description of the device
CHANNEL+ button
LCD display
ZERO button
CHANNEL- button
15-channel transmitter
1. Open the battery case to obtain access to the battery.
2. Lifespan of the battery is ca. 1 year while executing approximately 4 commands per day.
3. The batteries need replacing when the receiver stops reacting while you press the buttons.
4. Pay attention to polarisation of the battery while replacing it.
5. After pressing ZERO button, number 0, which indicates a group channel, appears on the display. This channel shows all
active devices programmed on individual channels of the transmitter. Do not perform any programming procedures on the
group channel.
Batteries contain substances that may present risk to health or serious environment degradation. Used batteries must be
disposed of in specially marked containers.
UP button
STOP button
DOWN button
(front)
1. Control:
possibility to control 1 motor or a group of up to 20 motors on
each channel
2. Range:
up to 200 meters in open area,
up to 35 meters indoors
3. Battery:
CR2430
4. Power supply:
3 V
5. Dimensions:
80 x 80 x 15 mm
6. Signal power:
10 mW
7. Operation temperature:
from 0°C up to 50°C
8. Safety degree:
IP 30
P2 programming
P2
button
15-channel transmitter
1
M
battery
P2
(back)