YOODA MAGNETIC PRO YSH Instructions

MAGNETIC_PRO_15R YSH
To use the technical capability of MAGNETIC PRO YSH transmitters optimally, read the following instructions carefully. MAGNETIC PRO YSH transmitters
are compatible with all devices of YOODA SMART HOME system.
www.sukcesgroup.pl
MAGNETIC PRO YSH transmitters is control dedicated to bidirectional communication.
1. Technical data
MAGNETIC PRO YSH 15-channel remote control with a display,
white (MAGNETIC PRO_15R YSH)
The range given by the manufacturer is a variable value, depending on the conditions in the environment in which
the device works. Factors such as building structure, signal interference from other devices, etc. affect range.
2. Description of the device
CHANNEL - button
1. Move the back housing of the remote control down to access the battery and the programming button.
2. Battery life is ca. 1 year while executing approximately 4 commands per day.
3. The batteries need replacing when the receiver stops reacting while you press the buttons.
4. Pay attention to polarisation of the battery while replacing it.
Batteries contain substances that may present risk to health or serious environment degradation.
Used batteries must be disposed of in specially marked containers.
The product includes a battery. Swallowing a coin cell battery causes severe internal burns within 2 hours and can result
in death. Store new and used batteries away from children. If the battery compartment does not close safely, stop using
the product and keep it away from children. If you suspect that batteries might have been swallowed or placed in any body part,
seek medical care immediately.
LCD display
UP button
STOP button
DOWN button
CHANNEL + button
15-channel transmitter
(front)
1. Control:
possibility to control 1 motor or a group of up to 20 motors on each chan
2. Range:
up to 200 meters in open area,
up to 35 meters indoors
3. Battery:
CR2450
4. Power supply:
3 V
5. Dimensions:
130 x 45 x 12 mm
6. Signal power:
10 mW
7. Operation temperature:
from 0°C to 50°C
8. Safety degree:
IP 30
P2 programming button
15-channel transmitter
(back)
1